Bush Hog MID MOUNT ZERO TURN SERIES Operator's Manual download pdf (Page 8)

Align right main frame leg against the ZT frame joint

and perpendicular to the frame. Fasten with (4) 3/8 x

2 x 2-1/2” U-blots from the inside out. Flatwashers

should be used over the slotted holes at the bottom

leg of each U-bolt. (Figure 4)

Figure 4 Right Main Frame Leg U-Bolt

Assemble left main frame leg to opposite side of the

ZT frame as shown. (Figure 5)

Figure 5 Left Main Frame Leg

2-2 Preparing To Mount Grass Container

Remove the rue-ring cotter pins from the bottom

ends of the door opening linkages and disconnect

the linkages.

Remove hair pin clips, washers and pivot pins that

connect the mainframe to the grass container. The

parts may then be separated. Place the mainframe

onto the mainframe legs and fasten with (4) 3/8 x 1”

bolts and locknuts. (Figure 6)

Figure 6 Mainframe 3/8 x 1” Bolts

2-3 Attaching The Lift Handle To The

Aluminum Grass Container.

The various parts of the handle assembly must be

attached to the container frame. Figure 7 shows the

orientation and location of the components. Slide the

lift handle into the slot in the bracket on the grass

container. It may be necessary to remove the handle

grip to allow the handle to fit through the slot.

Before attaching the handle, hook one end of the

spring into the hole on the underside of the handle.

Hook the other end of the spring into the open hole

in the bracket. Fasten the handle to the frame using

3/8-16 x 2” hex bolt and two 3/8” serated flanged hex

nuts. The handle must be able to move freely in the

slot in the bracket. If not, check the spacing of the

parts on the pivot point bolt. At this point the handle

can pivot back and forth in the slot, but the spring

pulls the handle in towards the grass container. With

the handle in place, fasten the ball joint, (Figure 9) to

the end of the rod. Tighten to approximately half way

down the threads of the rod. slide the ball joint into

the hole on the latch hook. Tighten nut on end of ball

joint. Attach opposite end into the latch handle

(Figure 7). Place a washer on the rod and use a cot-

ter pin to hold in place. Adjust rod to allow hook to

close the box completely.

Refer to Figures 7, 8, 9 and 10 for exploded parts

drawing and photogrtaphs of complete assembly.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Comments to this Manuals

No comments

Bush Hog MID MOUNT ZERO TURN SERIES Operator's Manual Page 8

Comments to this Manuals

Related products and manuals for Lawnmowers Bush Hog MID MOUNT ZERO TURN SERIES