Bush Hog 865H Operator's Manual download pdf (Page 23)

Figure 5-2 Axle Cylinder Mounting Holes

Front Of Cutter

B.When installing the axle arms on the center sec-

tion, the longer spindle should be to the outside (hinge

side) providing a wider wheel base. The longer spindle

can be installed to either sid when dual wheels are in-

stalled on the wing, but it is preferred to have the

longer spindle to the inside.

C. There are three styles of axle arms available on

the 2715. Only the dual wheel and the tandem axle

arms are to be used n the center section. Only single

and dual axle arms are to be used on the wings. In-

stall the axle arm to the axle arm mounting bracket on

the axle weldments using one rubber washer, spring,

spring retainers, 1” x 7-1/2” bolt and 1” locknut. Install

pivot pin through axle mounting bracket and axle arm.

Be sure that square head of pin rests against stop on

side of axle arm mounting bracket. Align 3/8” bolt hole

in pivot pin with hole in retainer bushing and install bolt

and lock nut to retain pivot pin. Tighten 1” locknut until

outside dimension between spring retainers is 5”. (Fig-

ure 5-4)

Figure 5-4

5” Dimension

Rubber Washer

Axle Arm

E .If the wing sections are equipped with single

wheel option, the wheel should be assembled to the

outside of the axle arms.

F. Bolt tongue to center section using two 1” x 8-1/2”

bolts, locknuts and bushings.

G. Fasten linkage rods to the holes in the tongue

side plates using 1” x 5” pins, two 1” flatwashers and

roll pins.

H. Attach turnbuckle end of linkage rods to axle

using pins and cotter pins. (Figure 5-5)

I. There are three types of drawbar attachments

available for the Model 2715L, a cast iron non-flex cle-

vis, a 2” ball hitch or a heavy duty, Perma Level self-

leveling clevis.

Cast Clevis

- Remove large clevis pin from clevis and

slide pin into tongue with slotted hole to the bottom

side. Secure with two 5/8” x 6” bolts, lockwashers and

nuts. (Figure 5-6)

2” Ball Hitch - Install ball hitch weldment into tongue.

Install 5/8” x 6” bolts through “L” bracket on ball hitch

weldment and tongue top and bottom plates, secur-

ing with flatwashers, lockwashers and nuts. Install

clevis pin collar over end of pin and secure with 5/8” x

3-3/4” bolts and locknuts. (Figure 5-7).

Perma Level Hitch - Remove collar from clevis pin and

slide pin into tongue with the clevis on the bottom and

clevis pivot pin on the top. Replace the collar onto the

back of the pin and secure with the hardware pro-

vided. (Figure 5-8)

Figure 5-3 Wing Axle Assembly

Laminated And

Filled Aircraft Tires

5”

Figure 5-5 Cylinder Linkage Rods & Turnbuckles

Axle

Automotive And Large

Aircraft Tires

Figure 5-6

Cast Clevis

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Comments to this Manuals

No comments

Bush Hog 865H Operator's Manual Page 23

Comments to this Manuals

Related products and manuals for Compact Excavator Bush Hog 865H